Solar Gard Sterling 60 | High Visibility Spectrally Selective Window Film

Architectural Solar Control Window Film (Spectrally Selective / Sputtered Metal Alloy)

Clear, pressure-sensitive, water-activated adhesive (Standard for Sterling Series)

60 inches width

Custom order (per meter)

• Maximum Natural Light: With 64% visible light transmission, this film is lighter than Sterling 40 or 50, making it nearly undetectable on glass.
• Selective Heat Rejection: Selectively targets infrared heat, providing 53% IR Energy Rejection (@780-2500nm) without darkening the room.
• Preserves Views: Extremely low interior reflection (16%) and exterior reflection (17%) ensures night views are not obscured by a mirror effect.
• Fade Reduction: Blocks >99% of UV rays and has a fade reduction coefficient of 47%, protecting valuable merchandise and furnishings.
• Comfort: Rejects 44% of total solar energy, significantly cooling interiors without sacrificing brightness.

• Retail Storefronts: Allows potential customers to see inside clearly while protecting merchandise from sun damage.

• Luxury Residential: Ideal for rooms with large panoramic windows where homeowners do not want to compromise the view.

• Historic & Heritage Buildings: Provides modern solar performance without altering the external aesthetic or "look" of the facade.

• Museums & Galleries: Filters out harmful UV and heat to protect artwork while allowing natural illumination.

• Clean: Thoroughly clean the interior glass surface using a solution of water and a small amount of baby shampoo. Scrape off any debris with a glass scraper.

• Cut: Measure and cut the film to the window size, leaving a small excess (1 inch) on all sides.

• Spray: Generously spray the glass and the adhesive side of the film with the slip solution.

• Apply: Place the film onto the wet glass. The solution allows you to slide the film into the perfect position.

• Squeegee: Spray the face of the film to prevent scratching, then use a squeegee to push the water and air bubbles out from the center toward the edges.

• Trim: Use a hard card and a sharp knife to trim the excess film along the edges of the frame, leaving a 1/8" gap for thermal expansion.

• Dry: Allow the film to cure. Full adhesion typically occurs within 30 days.

• Nominal Thickness: 50 microns (2.0 mil)

• Tensile Strength: 2,110 kg/cm²

• Solar Heat Gain Coefficient (G-Value): 0.56

• Glare Reduction: 29%

• Winter U-Factor: 5.5 W/m²°C

• Fire Rating: Classification B-s1, d0 (SBI EN 13823) and R1, HL1/HL2, HL3 (EN 45545)

• Certifications: ISO 9001, ISO 14001